Troubleshooting; Technical Data - Qualcast Qhte600 Instruction Manual

Storage
IMPORTANT! Make sure that the hedge trimmer has been thoroughly cleaned before
storing it in a clean, dry and safe place, out of the reach of children.
Always fit the transportation blade guard when storing the hedge trimmer.
1. Switch the product off and disconnect it from the power supply before transporting it
anywhere.
2. Attach the blade sheath.
3. Always carry the product on its gripping surfaces.
4. Protect the product from any heavy impact or strong vibrations, which may occur
during transportation in vehicles.
5. Secure the product to prevent it from slipping or falling over.

Troubleshooting

WARNING!
Only perform the steps described within these instructions!
All further inspection, maintenance and repair work must be performed by an authorised
service centre or a similarly qualified specialist, if you cannot solve the problem yourself!
The following table provides solutions to common problems encountered with the hedge
trimmer:
Problem Possible cause
Product does not 1. Not connected to power supply
start
2. Power connection is loose
3. Other electrical defect to the
product
Product does not 1. Extension cord not suitable
reach full power
2. Power source (e.g. generator) has
too low voltage
3. Air vents are blocked
Does not cut Cutting device worn
20
Solution
1. Connect to power supply
2. Connect the power supply
properly
3. Check with a specialist
electrician
1. Use a proper extension
cord
2. Connect to another power
source
3. Clean the air vents
Have a specialist replace it

Technical Data

Model no.
Rated voltage
Input power
No load speed
Cutting length
Tooth gap
Protection class
Machine weight
NOISE AND VIBRATION DATA
Sound pressure level (L )
pA
Power sound level (L )
wA
Vibrations
The declared vibration value has been measured in accordance with a standard test
method and may be used for comparing one tool with another. The declared vibration value
may also be used in a preliminary assessment of exposure.
WARNING!
The vibration emission value during actual use of the tool can differ from the declared
value depending on the ways in which the tool is used. Identify safety actual conditions of
use (taking account of all parts of the operating cycle, such as the times when the tool is
switched off and when it is running idle, in addition to the trigger time).
The sound intensity level for the operator may exceed 85dB(A) and ear protection
measures are necessary.
HTEG55A-610
AC 230-240V~, 50Hz
600W
1750min -1
550mm
20mm
II
3.6kg
80.7dB(A), K : 3dB(A)
PA
103dB(A)
4.7m/s 2 , K: 1.5m/s 2
21