Table of Contents
Advertisement
Maintenance
Maintenance Schedule
Remove the battery before carrying out any adjustment, servicing or maintenance.
Your power tool requires no additional lubrication or maintenance. There are no user serviceable
parts in your power tool. Never use water or chemical cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust. Occasionally you may see sparks through the ventilation
slots. This is normal and will not damage your power tool.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
Troubleshooting
General Troubleshooting
The following chart lists problem symptoms, possible causes and corrective action, if your electric
hedge trimmer does not operate properly. If these do not identify and correct the problem, contact
your service agent.
WARNING! Always switch the product off, disconnect it from power supply and let the product cool
down before performing inspection, maintenance and cleaning work!
Problem
Hedge trimmer does not
operate
Hedge trimmer operates
intermittently
Motor runs but blades remain
stationary
Cutting blade hot
Cutting time per battery
charge too low
The blades are running slow
Battery charge indicator(a)
does not light up
18
Possible Cause
1.1 Battery discharged
1.2 Battery not fully
connected
2.1 Internal wiring damaged
2.2 On/Off switch defective
3. Internal fault
4.1 Cutting blade dull
4.2 Cutting blade is damaged
4.3 Too much friction, due to
lack of lubricant
5.1 Too much friction, due to
lack of lubricant
5.2 Blade needs cleaning
5.3 Battery not fully charged
6.1 Battery discharged
6.2 Battery stored outside of
battery temperature
7.1 Mains plug of battery char-
ger not plugged in (properly)
7.2 Socket outlet, mains cable
or battery charger defective
Customer Helpline 0344 801 0979
ORIGINAL INSTRUCTIONS
Corrective Action
1.1 Recharge battery; also see
"Charging The Battery"
1.2 Ensure the battery pack re-
lease button is fully locked
2. Contact Helpline
3. Contact Helpline
4.1 Have blade sharpened
4.2 Have blade inspected/over-
hauled
4.3 Apply lubricant spray
5.1 Apply lubricant spray
5.2 Clean blade
5.3 Recharge battery; also see
"Charging The Battery"
6.1 Recharge battery; also see
"Charging The Battery"
6.2 Allow battery to warm natu-
rally to room temperature (within
battery operating temperature
10–45 °C)
7.1 Insert mains plug (fully) into
the socket outlet
7.2 Contact Service Agent
Hide quick links:
Advertisement
Table of Contents
