Qualcast Qhte600 Instruction Manual page 6

• Do not try to grasp or remove hedge clippings when the
hedge trimmer is running. Only remove hedge clippings
when the appliance is switched off and disconnected
from the mains supply.
• Carry the hedge trimmer by the handle while the cutter
blade is not running. Always ensure the guard supplied
is fitted when transporting or storing the hedge trimmer.
Careful operation reduces the injury by the cutter blade.
• Keep the cable away from the cutting area. Be aware
that, during operation, the cable may be covered in
hedge clippings and could be cut inadvertently.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• Read these safety instructions thoroughly before
connecting this product to the mains supply.
• Before switching on, make sure that the voltage of your
electricity supply is the same as that indicated on the
rating plate. This product is designed to operate on
230-240VAC 50Hz. Connecting it to any other power
source may cause damage.
• This product may be fitted with a non-rewireable plug. If
it is necessary to change the fuse in the plug, the fuse
cover must be refitted. If the fuse cover becomes lost
or damaged, the plug must not be used until a suitable
replacement is obtained.
• If the plug has to be changed because it is not suitable
for your socket, or due to damage, it should be cut
off and a replacement fitted, in line with the wiring
instructions shown below.
10
• The old plug must be disposed of safely, as insertion
into a 13amp socket could cause an electrical hazard.
• A 13amp fuse must be fitted. The use of a high-
sensitivity residual current device (RCD) is
recommended, to provide personal protection against a
harmful electric current.
• Do not use two-core extension cords or reels on power
tools with an earth path.
• Use only extension cords suitable for outdoor use,
preferably with a high-visibility cable colour. Always
unwind all extension cables fully, coiled cables can
overheat and reduce the efficiency of your product.
• For extension cables up to 15 metres, use a wire cross
section of 1.5mm . For extension cables over 15 metres
2
but less than 40 metres, use a wire cross section of
2.5mm .
2
• If the insulation on a power cable or extension lead is
found to be cut or damaged, do not touch it! Disconnect
the power supply immediately and have the damaged
cable replaced.
• Do not repair damaged cables.
• Always follow the manufacturer's instructions.
11