Technical Data - Graco Ultra-Lite 240-200 Instructions-Parts List Manual

Category
Maximum working pressure
Maximum temperature
Flow rate at 2000 psi (14 MPa, 138 bar)*
Outlet port size
Inlet port size
Dry weight
Length
Width
Thickness
Pressure vessel material
Pressure vessel ID
Gun seat diameter
Needle seat type
Inlet/outlet angle
Trigger force – breakaway @ 1000 psi
(7 MPa, 69 bar)
Trigger force – breakaway @ 2000 psi
(14 MPa, 138 bar)
Trigger force – sustaining
Wetted parts
CV75r is a registered trademark of the International Seal Co., Inc.
* Flow rates were measured using PVC sealer dispensed through a 1/8 in. diameter orifice nozzle and z-swivel con-
nected to inlet. Actual flow rates will vary depending on material type, fluid pressure, nozzle size, and system con-
figuration.
8 308-807

Technical Data

Data
3400 psi (23.4 MPa, 234 bar)
120_ F (49_ C)
Model 240–199: 158 oz/min (4.5 kg/min)
Model 240–200: 154 oz/min (4.4 kg/min)
1/4 npt(f) and flange
1/4 npt(f)
Model 240–199: 11.6 oz (325 gm)
Model 240–200: 11.6 oz (325 gm)
5.9 in (15.0 cm)
2.6 in (6.6 cm)
0.85 in (2.16 cm)
Aluminum
0.25 in (6.4 mm)
Model 240–199: 0.125 in (3.2 mm)
Model 240–200: 0.203 in (5.2 mm)
Model 240–199: Carbide ball
Model 240–200: 7_ Tapered carbide
20_
Model 240–199: 1.6 lb (0.73 kg)
Model 240–200: 3.8 lb (1.72 kg)
Model 240–199: 2.2 lb (1.0 kg)
Model 240–200: 7.3 lb (3.31 kg)
Model 240–199: 3.2 lb (1.45 kg)
Model 240–200: 2.8 lb (1.27 kg)
Aluminum, stainless steel, carbide, polyethylene, CV75r