Technical Data; Accessories - Graco PRO 5500hc Instructions Manual

Category Data
Gun Weight (gun 3.57 lb (1620 g)
and manifold)
Maximum Working 100 psi (7 bar, 0.7 MPa)
Pressure
Air Pressure 0–100 psi (0–7 bar,
Operating Range 0–0.7 MPa)
Fluid Pressure 0–100 psi (0–7 bar,
Operating Range 0–0.7 MPa)
Voltage Output 0–85 kV
Short Circuit Current 120 A
Output
Paint Resistivity 3 megohm-cm to infinity
Range
Maximum Fluid 120 F (49 C)
Temperature
Turbine Air Inlet 1/4 npsm(m) left-hand
Typical Noise Level Sound Pressure
at 40 psi (2.8 bar, Sound Power
0.28 MPa)
MISCELLANEOUS ACCESSORIES
Grounding Clamp and Wire 222–011
12 ga, 25 ft (7.6 m) wire
Megohmmeter 218–979
500 Volt output; 0.01–2000 megohms.
Not for use in Hazardous areas.
Paint Resistance Meter 722–886
Used with 722–860 Paint Probe to measure resistance
of paint. Not for use in Hazardous areas.
Paint Probe 722–860
Used with 722–886 Paint Resistance Meter to mea-
sure resistance of paint. Not for use in Hazardous
areas.
46 308–442

Technical Data

91 Db(A)
90.7 Db(A)

Accessories

Use Only Genuine Graco Parts and Accessories
Maximum Noise Sound Pressure
Level at 100 psi Db(A)
(7 bar, 0.7 MPa) Sound Power
Wetted Parts Stainless Steel, Nylon, Acetal,
PTFE
Molecular Weight
Polyethylene, Ceramic,
Chemraz , Fluoro-polymer,
Music Wire
Sound pressure was measured per Cagi Pneurop, 1969.
The measurement was taken 3.28 feet (1 meter) from the
air cap.
Sound power was measured per ISO–3744, 1981.
PTFE , Viton , and Kalrez are registered trademarks of the
Co.
Loctite is a registered trademark of the Loctite Corporation.
Chemraz is a registered trademark of the Green, T weed, &
Co.
This is the allowable paint resistivity range for this gun.
Note that electrostatic effect may drop off below about 25
megohm cm.
Safety Warning Signs
FM Approved; Available at no charge from Graco.
Must be ordered separately.
180–060 Warning Sign (English)
180–061
Warning Sign (French)
180–062
Warning Sign (German)
180–063 Warning Sign (Spanish)
Gun High Voltage Probe & Meter 217–452
For direct measurement of gun output voltage.
KV Display Module 189–762
Receives fiber optic transmission from the gun and
displays the gun's output voltage. Battery operated.
ES Display Module 224–117
Receives fiber optic transmission from the gun and
displays the gun's output voltage and current. Mounts
in a standard 19" DIN Rack.
24 Volt Power Supply 235–301
Provides 24 volt power for up to 23 ES Display Mod-
ules.
101.5
107 Db(A)
, Kalrez , Ultra High