Advertisement
Quick Start-up Guide
for geared/induction motor applications
Please refer to the 'Optidrive P2 Elevator User Guide' for
Slide out help card
complete safety and operating instructions, this can be found
Quick reference to
at www.invertekdrives.com or by scanning this QR code
travel curve setup
Step 1 Electrical connections
Back-lit elevator logo
Step 2 Motor nameplate data entry
Logo flashes if the drive
trips
Step 3 Encoder nameplate data entry
Step 4 Motor auto-tune
Pluggable control
Control terminal connections
terminals
Speed profile setup
RJ45 port
Digital input configuration parameter (P1-13)
Modbus/CanOpen
connection
Optimising & improving travel comfort
Fault messages
Expansion slot
Encoder Interface
Useful parameters
(if an encoder is used)
(default)
OPTIDRIVE elevator | Quick Start-up Guide | Version 1.0
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Invertek Optidrive Elevator
Summary of Contents for Invertek Optidrive Elevator
- Page 1 (default) Speed profile setup RJ45 port Digital input configuration parameter (P1-13) Modbus/CanOpen connection Optimising & improving travel comfort Fault messages Expansion slot Encoder Interface Useful parameters OPTIDRIVE elevator | Quick Start-up Guide | Version 1.0...
-
Page 2: Step 1 Electrical Connections
(P7-01 thru to or . P7-06 will be populated). Note: Motor Auto-tune will need to be repeated if the motor, motor cables, motor parameters or drive control mode is changed in P4-01. OPTIDRIVE elevator | Quick Start-up Guide | Version 1.0... -
Page 3: Digital Input Configuration Parameter (P1-13)
** If 0 drive will fast stop using deceleration ramp in time set in P2-25., if P2-25 is zero the drive will P3-02 (Accel end Jerk) coast to stop. P3-03 (decel start Jerk) P3-04 (decel end Jerk) P3-05 (Stopping Jerk) OPTIDRIVE elevator | Quick Start-up Guide | Version 1.0... - Page 4 0,1,2 3 – too early Use motor Brake control option 2, see Jerk Felt 10.6.2 During Deceleration P4-01 = Increase P3-01 (Acceleration S-Ramp stopping time too 0,1,2 1 duration) short OPTIDRIVE elevator | Quick Start-up Guide | Version 1.0...
-
Page 5: Fault Messages
This occurs routinely when power is switched off. P4-03 Speed loop P-gain DC bus If it occurs during running, check the incoming supply voltage, and P4-04 Speed loop I-gain all connections into the drive, fuses, contactors etc. OPTIDRIVE elevator | Quick Start-up Guide | Version 1.0...
Need help?
Do you have a question about the Optidrive Elevator and is the answer not in the manual?
Questions and answers