Advertisement
Multichannel STM-1 Port Adapter for the Cisco 7500 Series Router
tug-2 e1 shutdown
To shut down an individual E1 line that has been mapped to a TUG-3, use the tug-2 e1 shutdown
configuration controller tug-3 command.
To shut down an individual E1 line that has been mapped to an AU-3, use the tug-2 e1 shutdown
configuration controller au-3 command.
To enable an individual E1 line, use the no form of this command.
Syntax Description
tug-2 number
e1-number
shutdown
Defaults
E1 lines are not shut down.
Command Modes
Configuration controller tug3 (for an E1 line mapped to a TUG-3)
Configuration controller au3 (for an E1 line mapped to an AU-3)
Command History
Release
12.0(14)S
Usage Guidelines
Use the tug-2 e1 shutdown command in configuration controller tug3 command mode to shut down an
individual E1 line that has been mapped to a TUG-3 via the aug-mapping au-4 command.
Use the tug-2 e1 shutdown command in configuration controller au3 command mode to shut down an
individual E1 line that has been mapped to an AU-3 via the aug-mapping au-3 command.
Examples
The following example shuts down E1 line 1, that has been mapped to a TUG-3:
Router(config)# controller sonet 2/0/0
Router(config-controller)# aug mapping au-4
Router(config-controller)# au-4 1 tug-3 2
Router(config-ctrlr-tug3)# tug-2 4 e1 1 shutdown
The following example shuts down E1 line 1, that has been mapped to an AU-3:
Router(config)# controller sonet 2/0/0
Router(config-controller)# aug mapping au-3
Router(config-controller)# au-3 1
Router(config-ctrlr-au3)# tug-2 4 e1 1 shutdown
tug-2 tug-2 number e1 e1-number shutdown
[no] tug-2 tug-2 number e1 e1-number shutdown
A number in the range of 1 to 7.
A number in the range of 1 to 3.
Shuts down an individual E1 line.
Modification
This command was introduced.
tug-2 e1 shutdown
12.0(14)S
43
Advertisement
