Primary Drive Gear - Yamaha GT1 Service Manual

INGINE -
Clutch · Primary Drive Gear
J. Adjusting the Clutch
1
I
Adjusting Screw Adjustment
Remove the generator cover and loosen the
push screw lock nut located inside. Then turn
in the push screw to a lightly seated position
so that the push screw will have no excessive
play nor be too tight. Next back out ¼ turn
and set it with the lock nut.
Fig. 4-9-15
2)
Adjusting the Clutch Cable Tension
The clutch cable becomes slackened after being
used for a long time.
Occasionally the cable must be adjusted so that
the play at the clutch lever is frbm 2 to 3 mm
(1/16 ~1/8
in.).
Fig. 4-9-16
-30-
4-1 0. Primary Drive Gear
A. Removal
Feed a roll-up rag between the teeth of the
primary drive gear and the primary driven gear
to lock them, and loosen the primary drive gear
lock nut.
The primary drive gear can then be forced off as
shown in Fig. 4-10-2.
Fig. 4-10-1
Fig. 4-10-2