Attaching Speakers - Sharp Aquos LC 26GD4U Operation Manual

Preparation

Attaching speakers

1
Remove the terminal cover as shown in the
illustration.
2
Insert the projecting bulges on the side of the
speakers into the corresponding slots in the
display.
3
Fasten the screw.
4
Fasten the speaker cable with the holder. Connect
the ends of the cable to the speaker terminals as
shown in the illustration.
CAUTION
• Do not remove the stand and speaker from the Display unless using an optional bracket to mount it.
• Before performing work spread cushioning over the base area to lay the Display on. This will prevent it from
being damaged.
NOTE
• Perform the same steps for right speaker.
• To attach the speakers, perform the steps in reverse order.
The illustration shows the LC-32GD4U.
5
Attach the speaker terminal cover.
6
Align nub of the bracket with the groove and slot it
into place.
7
Screw
(SILVER)
Fasten the bracket with the screw.
8
Attach the terminal cover as shown in the
illustration.
Screw
(BLACK)
11