Table of Contents
Advertisement
ROA 128 5151
PIM Evaluation Board
3c
Output Management Power 2.
3d
Output Management Power 3.
4
Power Good.
5
Hold Up Voltage.
6
Male/female board-to-board connectors. Connectors are used to connect
the board to other 3E evaluation boards. All interconnected boards are
sharing the same PMBus and Sync signals. Only one PMBus-to-USB
adaptor is needed. The following signals are connected to the board to
board connectors: SYNC, SALERT, SCL, SDA, CTRL, VI2C, DGND.
7
Enable switch A and B.
8a
Connector for the Flex Power KEP 910 17 PMBus-to-USB adaptor.
It is found on reverse side of the board.
9a
Position for PIM 4820.
9b
Position for PIM 4328.
10
PIM I/O Connector. The following signals are connected to the PIM I/O
connector: SALERT, SCL, SDA, CTRL, VI2C DGND, +OUT2 for all
products and +OUT3 for PIM 4328.
User Guide
1/28701-ROA 128 5151 Rev A
© Flex
5
May 2018
Advertisement
Table of Contents
