Functional Description; Wall Mounting; Charging The Battery - Black+Decker HHVJ315JDP27 Instruction Manual

10 • ENGLISH
WARNING: Do not attempt to modify or repair the
appliance
SAVE THESE INSTRUCTIONS
Symbols
• The label on your tool may include the following
symbols. The symbols and their definitions are as
follows:
V .......................volts
A .......................amperes
Hz.....................hertz
W......................watts
min ...................minutes
or AC ..........alternating current
or DC ......direct current
n o .....................no load speed
....................Class I Construction
(grounded)
.....................earthing terminal
...................safety alert symbol
....................Class II Construction
(double insulated)
.../min or rpm...revolutions or reciprocation
per minute

FUNCTIONAL DESCRIPTION

1. On/off power button
2. Handle
3. Nozzle
4. Extendable crevice tool
5. Crevice tool release button
6. LED BATTERYSENSE (SMARTTECH vacuums only)
7. LED POWERBOOST indicator
8. Dust bowl
9. Dust bowl release button
10. FilterSense LED (SMARTTECH vacuums only)
11. Charging base
12. Jack plug charger
13. Motorized pet head
14. Motorized pet head release button
15. Brush tool

WALL MOUNTING

The product can be attached to a wall to provide a
convenient storage and charging point for the appliance.
When mounting to a wall, make sure the mounting method
is suitable for the wall type and is appropriate to the weight
of the appliance.
• Mark the location of the charger base ( 12 ) screw
holes on the wall (within reach of an electrical outlet for
charging the vacuum while it is on the charging base).
• Fix the charging base to the wall using appropriate
screws and plugs for the type of wall, and weight of
the appliance.
• Hang the appliance by placing the opening of the
vacuum base over the hooks in the charging base.

CHARGING THE BATTERY

WARNING: For use only with the supplied charger.
• Before first use, the battery must be charged for at
least 6 hours.
• HHVJ325B ONLY: Place the appliance on the
charging base ( 11 ) whenever it is not in use as
shown in Figure B.
• HHVJ315J, HHVJ325J ONLY: Plug the jack plug
charger ( 12 ) into the charging socket of the tool as
shown in Figure C. Plug the charger into any standard
120 Volt 60 Hz electrical outlet or 220 Volts 50 Hz for
the 220V models.
WARNING:
Before charging, be sure to empty all
contents and dry thoroughly if needed to avoid damage to
your appliance.
• Make sure the appliance is switched off. The battery
will not be charged when the on/off switch ( 1 ) is in
the on position.
NOTE:
While charging, the charger may become warm.
This is normal and does not indicate a problem. The
appliance can be left connected to the charger indefinitely.
NOTE: The vacuum can not be charged while the pet head
( 13 ) is attached..
WARNING:
Do not charge the battery at ambient
temperatures below 50 °F or above 104°F.
SWITCHING ON AND OFF - FIGURE D
• HHVJ325B, HHVJ325J ONLY: To switch the appliance
on, depress the on/off button ( 1 ). The battery
indicator LED will illuminate and vacuum will begin in
the low-speed mode.
• HHVJ315J ONLY: To switch the appliance on, depress
the on/off button ( 1 ). The vacuum will begin in the
low-speed mode.
NOTE:
When battery life is nearly depleated, the battery
indicator LED will illuminate and flash.
• Depress the button a second time to engage the
POWERBOOST mode. The green LED will also
illuminate, indicating the vacuum is in the higher-
speed mode.
• To switch the appliance off, depress the button a third
time.