Quick Start: Learning How to Make Measurements
Learning to Make Reflection Measurements
Measuring Other Reflection Characteristics
You can derive several important filter parameters from the measurement shown on the
analyzer display. The following set of procedures is a continuation of the previous
reflection measurement procedure.
Measuring Reflection Coefficient.
1. Press
,
Save/Recall
RECALL STATE
saved earlier in this procedure.
2. Press
,
Format
LIN MAG
reflection coefficient, as shown in
The units "mU" displayed on the analyzer are "milli-units," where "units" or "U" is used
to indicate that the parameter is unitless (as opposed to log or linear). For example, 200
mUnits = 0.2.
Figure 2-12
Example Reflection Coefficient Measurement Trace
46
to recall the calibrated reflection measurement that you
,
,
so the analyzer shows the same data in terms of
Scale Ref
AUTO SCALE
Figure
2-12.
Chapter 2