To Test The Transmission Mode - HP 8753E Installation And Quick Start Manual

Network analyzer

Hide thumbs Also See for HP 8753E:

Table of Contents

Installing Your Analyzer

STEP 5. Verify the Analyzer Operation

To Test the Transmission Mode

1. Connect the equipment as shown and

press

. NOTE: The test port return

Preset

cable should have low-loss characteristics to

avoid a degradation in frequency response

at higher frequencies.

3. Look at the measurement trace displayed

on the analyzer. It should be similar to the

trace below. NOTE: The analyzer display

shown below and to the right is an HP

8753E Option 006 display (30 kHz to 6 GHz

span).

2. To check the forward transmission mode

for channel 2, press

Chan2

Trans:FWD S21(B/R)

4. To check the reverse transmission mode

for channel 2, press

Meas

The measurement trace should be similar to

the trace below.

Meas

Trans: REV S12 (A/R)

Chapter 1

Table of Contents