Table of Contents
Advertisement
INSTALLATION
Disconnect BATTERY and AC
prior to working on equipment.
The PSX-12C mounts on the
Mounting Plate (CAB-MP). The
Mounting Plate may be located
either "IN" or "OUT" of the
enclosure to perform this
installation procedure. If the
Mounting Plate is located "IN"
the enclosure you will have to
gain access to it by opening the
enclosure Inner and Outer
doors. If the Mounting Plate is
located outside of the enclo-
sure, place it in front of you so
that the word "TOP" is at the
top and away from you.
The PSX-12C can occupy any
position on the mounting plate,
but it should be installed in the
row and position that is located
directly above the PTB to
which it is connected. (Refer to
Figures 3 and 5). When the
PSX-12C is mounted correctly
on the Mounting Plate it will be
flush on the top, bottom, and
right with the Mounting Plate
and the mounting screw holes
of the PSX-12C will align with
the threaded posts.
1.
Install four M5 screws in
the threaded posts at the
mounting position. Screw
each of the M5 screws
into the threaded posts 5-6
turns.
2.
Place the PSX-12C over
the four screws on the
Mounting Plate and slide it
down or towards you to
rest on the four screws.
(Refer to Figure 4.) When the PSX-12C is in the correct position it will be flush
with the top, bottom and right side of the Mounting Plate.
3.
Tighten the four screws.
Figure 3
Location Of The PSX-12C On The MP-M
MOUNTING PLATE MP-M
CAB-MP
Figure 4
Mounting The PSX-12C On The MP-M
5
SLIDE DOWN UNTIL
,
T
FLUSH ON TOP,
OM
RIGHT
RIGHT, AND BOTTOM
PSX-12C
PSC-12
A24205-A334-B818
P/N 315-035840-1
Advertisement
Table of Contents
