Troubleshooting - Honeywell Lutron VisionPRO 8000 User Manual

Troubleshooting

If you have difficulty with your thermostat, try these suggestions. Most problems can
be corrected quickly and easily.
Screen is blank
Screen is
difficult to read
Red light is on
Heating or
cooling system
does not
respond
33-00066EFS—03
• Check circuit breaker and reset if necessary.
• Make sure power switch at heating and cooling system is on.
• Make sure furnace door is closed securely.
• Change screen brightness using Preferences menu (see page 32).
• If thermostat is in Emergency Heat mode, the red light is normal. It shows
that the thermostat is in Emergency Heat mode.
• If thermostat is not in Emergency Heat mode, an alert is active. Check
message on the thermostat screen.
• Touch SYSTEM to set system to Heat. Make sure the temperature is set
higher than the Inside temperature.
• Touch SYSTEM to set system to Cool. Make sure the temperature is set
lower than the Inside temperature.
• Check circuit breaker and reset if necessary.
• Make sure power switch at heating & cooling system is on.
• Make sure furnace door is closed securely.
• If "Wait" is displayed, the compressor protection timer is on. Wait 5 minutes
for the system to restart safely, without damaging the compressor.
45