Sharp LC-M3700 Operation Manual page 61

Settings and Adjustments (Continued)
[Example: 4] Disabling remote control, monitor buttons and power operations (RS-232C daisy-chain
connection)
Note: Values returned by monitors are omitted because they vary depending on the number of
connected monitors.
PCL+xxxx
LREM001+
LBTN001+
LPOW001+
PSE+xxxx
[Example: 5] Disabling remote control operation, operation using monitor buttons, and switching to the
power standby state using those controls for a specific monitor (example: ID=2) in a chain
of monitors connected via RS-232C.
Note: Response messages are omitted for convenience as the number of connected monitors
varies.
IDLK0002
PCLRxxxx
LREM0001
LBTN0001
LPOW0001
PSETxxxx
IDLK0000
If you forget your PIN
If you forget the PIN which you yourself set, perform the following operation when the PIN input screen
is displayed.
This allows you to temporarily unlock the function.
60
US
←("xxxx" is the current PIN. "xxxx" is not necessary if no PIN is set.)
←Locks remote control
←Locks monitor buttons
←Locks power operation
←("xxxx" is new PIN.)
←Select monitor with ID=2
←("xxxx" is the current PIN. "xxxx" is not necessary if no PIN is set.)
←Locks remote control
←Locks monitor buttons
←Locks power operation
←("xxxx" is new PIN.)
←Exit "IDLK" command
|
\
ENTER MENU