Mounting Options - Sharp LC-M3700 Operation Manual

I Please use an optional table stand or wall-mount bracket designed specifically for this
product.
This monitor is equipped with a temporary stand when shipped from the factory. Please
Mounting
note this stand is for temporary use only until the monitor is properly mounted. Be sure to
precautions
use a special-purpose AN-37ST1 table stand or AN-37AG1 wall-mount bracket (both
optional).
Mounting the table stand (AN-37ST1) (LC-M3700)
See the table stand instructions for details.
M5 screws 25 mm length
(5 screws)
Stand base
Stand hinge
Terminal cover
Temporary stand
M5 screws 12 mm length
(4 screws)
Table stand
Wide LCD Monitor
Table
Soft cloth, etc.

Mounting Options

1. Assemble the table stand.
G Align the 5 screw holes of the stand base with
the corresponding screw holes of the stand
hinge. Then attach the stand base to the stand
hinge using the supplied 5 screws (M5 25 mm
length).
2. Detach the temporary stand.
GPlace the monitor (face down) on a table, etc.
covered by a thick, soft cloth for LCD panel
protection.
GPosition the monitor near the edge of the table so
that the temporary stand does not hit the table,
then remove the terminal cover.
GUnfasten the 4 screws used to secure the
temporary stand in place, then remove the stand.
3. Attach the table stand assembled in
step 1 to the back of the monitor using
the supplied 4 screws (M5 12 mm
length).
GAfter installation, close the terminal cover, and
adjust the monitor to a suitable angle. (Tilting
range: up to 4˚ forward and 6˚ backward.
Rotating range: up to 10˚ clockwise and
anticlockwise.)
23
US