Sharp LC-M3700 Operation Manual page 26

Setting the angle of the wall-mount bracket
I The wall-mount bracket is assembled for perpendicular installation, so to use it for tilted installation,
please follow the procedure below to set it at the installation angle.
Wall-mount bracket
Installation angle:
LC-M3700 (Horizontal mount) 0° to 20°
LC-M3710 (Vertical mount)
Attaching wall-mount bracket to the monitor
Terminal cover
Temporary stand
0°
Install so that the
angle-setup bracket
spacers are facing
inward.
Screws
(4 locations)
Wide LCD Monitor
Table
Soft cloth, etc.
Mounting Options (Continued)
Setting the installation angle.
1 Remove the 2 vertical installation screws. These
screws are used when setting the angle in step
3.
2 Assemble the wall-mount bracket as desired as
shown in the figure. (Figure shows a 20˚ angle.)
3 Use the screws removed in Step 1 (M6 15 mm
length × 2 screws) and the included screws M6
15 mm length × 2 screws to loosely fasten the
angle-setup bracket with 4 screws. Firmly
tighten these 4 screws after the angle-setup
bracket position has been determined.
• When setting the angle of the wall-mount bracket,
be careful not to pinch your fingers, etc.
Caution
Screws M6 15mm length (4 screws)
Wall-mount bracket
1. Detach the temporary stand.
GPlace the monitor (face down) on a table, etc.
covered by a thick, soft cloth for LCD panel
protection.
GPosition the monitor near the edge of the table so
that the temporary stand does not hit the table, then
remove the terminal cover.
GUnfasten the 4 screws used to secure the
temporary stand in place.
As the screw hole numbers become larger
(5, 10,15, 20), the Wide LCD Monitor will be
tipped farther forward.
Angle setup bracket (2 units)
25
US