Function Settings - Mitsubishi Electric Lossnay LGH-150RVXT-E Installation Instructions Manual

Function settings

Address setting is required when connecting to City Multi and MELANS.
Setting the address
Use the following procedure when setting the address for dedicated
Lossnay.
(The method in determining the addresses will depend on the existing
the circuit board.
SA1 SA2
10s digit 1s digit
memory is automatically reset.
Changing the function selection
switches (SW-2, 5 and 6)
function.
* All function except "Trial operation" and "Main unit setting" can be
the setting on the remote controller.
(SW2)
OFF ON
1
Trial operation
2
Pulse input setting
3 No. 63
No. 6 Indoor negative pressure setting
4
5 Indoor positive pressure setting
No. 63
6
No. 51 Automatic ventilation mode setting
7
8
No. 61
9
No. 62 Fan speed for air volume "Low" input
10
(SW5)
OFF ON
No. 9 Delay start setting for air conditioner starting
1
2
No. 13 No. 14
3
No. 5 Automatic recovery setting after power interruption
4
No. 1
5
By-pass monitor output or Pre-heater output setting
6
No. 15 Interlock mode setting
7
No. 15 Interlock mode setting
8
No. 14
9
10
Address setting switch
Exhaust fan setting
Change the function settings from the
remote controller PZ-61DR-E.
function settings.
DIP-SW 6 is to idenify the model for PCB.
setting as old one.
* Do not change from factory setting.
SW6-1 SW6-2 SW6-3 SW6-4
OFF ON OFF ON
ON ON OFF ON
OFF OFF ON ON
Eng-13