Section 1: Introduction; General Service Information - Emerson Bettis CBA*30-SR series Service Instructions Manual

Service Instructions
137463E Rev. D

Section 1: Introduction

1�1

General Service Information

1.1.1
Table 1�
(1) Also includes actuator models with –10 and –11 as a suffix
NOTE:
When the actuator model number has "-S" as a suffix then the actuator is special and may
have some differences that may not be included in this procedure.
1.1.2
NOTE:
Storage time is counted as part of the service interval.
1.1.3
1.1.4
1.1.5
1.1.6
1.1.7
1.1.8
CAUTION: FOLLOW MANUFACTURER'S INSTRUCTIONS
Apply the thread sealant per the manufacturer's instructions.
1.1.9
Introduction
This service procedure is offered as a guide to enable general maintenance to be
performed on Bettis™ CBAX30-SR spring-return series actuators. The following is
a list of general CBAX30 SR model numbers:
CBAX30-SR Model Numbers
MODEL (1)
CBA730-SR
CBA830-SR
CBA930-SR
CBA1030-SR
Normal recommended service interval for this actuator series is five years.
This procedure is applicable with the understanding that all electrical power and
pneumatic pressure has been removed from the actuator.
Remove all piping and mounted accessories that will interfere with the module(s)
that are to be worked on.
This procedure should only be implemented by a technically competent technician
who should take care to observe good workmanship practices.
Numbers in parentheses, ( ) indicate the bubble number (reference number) used
on the Bettis assembly drawing and Actuator Parts List.
When removing seals from seal grooves, use a commercial seal removing tool or a
small screwdriver with sharp corners rounded off.
Use a non-hardening thread sealant on all pipe threads.
Bettis recommends that disassembly of the actuator should be done in a clean
area on a workbench.
Section 1: Introduction
MODEL (1)
CBA730-SR-M3
CBA830-SR-M3
CBA930-SR-M3
CBA1030-SR-M3
August 2015
MODEL (1)
CBA730-SR-M3HW
CBA830-SR-M3HW
CBA930-SR-M3HW
CBA1030-SR-M3HW
1