Table of Contents
Advertisement
Problem
Power is on but copying
is not possible.
Lighting fixture flickers.
Is the POWER SAVE (
indicator blinking?
Is the
indicator on?
Is
blinking in the copy
quantity display?
Is
steadily lit in the copy
quantity display?
Is the
indicator blinking?
Is the
indicator blinking?
Is the START key (
) indicator
blinking?
Is the same power outlet used for
the lighting fixture and the copier?
Be sure to use only genuine SHARP parts and supplies.
Please contact your SHARP service center immediately if a problem persists
after checking the above.
Self-diagnostic function
An automatic self-diagnostic function is built into the copier. Should the
copier malfunction, the self-diagnostic function will locate the problem and
stop the copier to prevent damage. An alphanumeric code will appear in the
copy quantity display.
Example
Should the copier completely stop and a letter and a number appear alternately,
contact your SHARP service center immediately.
COPIER TROUBLE?
Solution
)
Wait until warm-up is complete.
Warm-up time is approximately 35 seconds.
Copy paper is needed. See page 13, LOADING
COPY PAPER.
The TD cartridge is not installed. Install the
TD cartridge.
Side cover is open.
Close the front and side covers securely.
The TD cartridge must be replaced. See page
32, TD CARTRIDGE REPLACEMENT.
A misfeed has occurred. See page 36,
MISFEED REMOVAL.
Toner replenishment takes up to 2 minutes.
Wait until the START key (
stops blinking.
Connect the copier to a power outlet which is
not used for other electric appliances.
) indicator
49
Advertisement
Table of Contents
