Table of Contents
Advertisement
PWR/FAULT LED Is Not Lit When the NI CVS-1459 is
Powered On
If the system power supply is properly connected (polarity is not reversed) to the
NI CVS-1459, but the PWR/FAULT LED does not light up, check that the power supply is
within the specifications listed in the NI CVS-1459 Specifications. Using a power supply that
is not within these specifications might result in an unresponsive or unstable system and could
damage the device.
If the BIOS setting Restore After Power Loss is set to Stay Off, the NI CVS-1459 may be
powered, but turned off. Press the RESET button to power on the device.
Where to Go Next
The following documents and resources contain information you may find helpful as you use
the NI CVS-1459 in an application. Refer to the National Instruments Product Manuals
Library at
ni.com/manuals
•
NI CVS-1459 Specifications—Contains detailed specifications for the NI CVS-1459.
•
NI CVS-1459 Getting Started Guide—Explains how to install and configure the software
necessary to use the NI CVS-1459, and how to get started using the hardware.
•
NI CVS I/O Accessory User Manual—Contains installation and operation instructions for
the NI CVS I/O Accessory.
Worldwide Support and Services
The NI website is your complete resource for technical support. At ni.com/support, you have
access to everything from troubleshooting and application development self-help resources to
email and phone assistance from NI Application Engineers.
Visit
ni.com/services
other services.
Visit
ni.com/register
support and ensures that you receive important information updates from NI.
A Declaration of Conformity (DoC) is our claim of compliance with the Council of the
European Communities using the manufacturer's declaration of conformity. This system
affords the user protection for electromagnetic compatibility (EMC) and product safety. You
can obtain the DoC for your product by visiting ni.com/certification. If your product supports
calibration, you can obtain the calibration certificate for your product at ni.com/calibration.
NI corporate headquarters is located at 11500 North Mopac Expressway, Austin, Texas,
78759-3504. NI also has offices located around the world. For telephone support in the United
States, create your service request at
telephone support outside the United States, visit the Worldwide Offices section of
for the most recent versions of product documentation.
for NI Factory Installation Services, repairs, extended warranty, and
to register your NI product. Product registration facilitates technical
ni.com/support
or dial 1 866 ASK MYNI (275 6964). For
NI CVS-1459 User Manual | © National Instruments | 29
ni.com/
Advertisement
Table of Contents
