Sharp AF-R100EX Installation And Operation Manual page 7

8
Insert the closure assemblies on both
sides into the rails of the jamb.
Closure assembly
(Left)
Sill
9
(1) Secure the cabinet to the window
stool with 2 screws (L=1", 25.4mm),
working from the inside of the cabinet.
(2)
Secure the top angle and the closure
assemblies to the window sash with 3
screws (L=1", 25.4mm).
(3)
Secure the closure assemblies to the
sill with 2 screws (L=1", 25.4mm).
10
(1)
Slide the chassis back into the cabinet.
(2) Replace the 3 screws removed in
step 3 to the Front and side of the cabinet .
11
(1)
Replace the front panel. Slip the ex-
haust lever through the opening
between the horizontal louver and the
front panel then, hook the cabinet top.
CAUTION:
Move the exhaust lever and the 3 ver-
tical louver levers thoroughly to the left
when replacing the front panel.Take
care not to damage the levers.
(2)
Screw the front cabinet on at the bottom
corners with 2 screws removed in step 2.
12
Cut the window sash foam seal to the
proper length and seal the opening be-
tween the top of the inside window sash
and the outside window sash.
Jamb
(Left)
1/2 inch (13mm)
Stool
INSTALLATION INSTRUCTIONS
Closure assembly
(Left)
Indoor
side
Normal screw
Scratching screw for
grounding.
Serration
Window sash foam seal
Top angle
Vertical louver lever
Horizontal
Louver
Exhaust
Front
Lever
Panel
7