Advertisement
JA Y B AS IC B AC K
The owner of this equipment is responsible for making sure that it
has been set up and adjusted by a Authorized Dealer under the
advice of a healthcare professional. It may require periodic safety
and function checks or certain in-use adjustments that can be per-
formed by the owner, caregiver or Authorized Dealer if desired.
A. MAINTENANCE AND CLEANING
1. Proper maintenance and cleaning will improve performance
and extend the useful life of your equipment.
2. Clean your equipment regularly. This will help you find loose
or worn parts and make your equipment easier to use. You
will need a mild detergent solution and cleaning rags.
3. If discovered, have loose, worn, bent or damaged parts
replaced before using the back support.
B. CRITICAL SAFETY CHECKS
1. Fasteners:
Sunrise Medical recommends that all fasteners be checked for
wear, such as loose bolts or broken components Every 6 months.
Loose fasteners should be retightened according to the installation
instructions.
2. Replacing components:
Contact your Authorized Dealer immediately to replace any com-
ponents. Do not continue to use the system after identifying
loose or broken components.
C. EASY CLEANING
1. Back Cover
a. Remove the cover from backshell by detaching the Velcro
Unzip the zipper on the bottom of the cover.
b. Remove the foam and turn the cover inside out.
c. Zip the cover closed to avoid snagging.
d. Machine wash in warm water (50°C).
e. Drip and tumble dry in on Low Heat.
NOTE – Do not dry clean covers or use industrial washers or dryers to
clean covers. Do not steam autoclave. Do not bleach. Laundry care symbol
definitions are shown (Fig. 1).
2. Back shell
a. The backshell should be wiped clean with soap and water on
a regular basis to prevent buildup of dirt and grime.
3. Strap and Support version
a. Loosen straps and remove back from the wheelchair.
b. Locate the zipper on the bottom of cover and unzip.
c. remove foam and plastic support shell and turn the cover
inside out.
d. Zip cover closed to avoid snagging.
e. Machine wash in warm water (50°C).
f. Drip and tumble dry in on Low Heat.
g. Reinsert the foam and support shell inside the cover and zip
the cover closed.
NOTE - Do not dry clean covers or use industrial washers and dryers to
clean cover. Do not steam autoclave. Do not bleach.
NOTE - The ABS plastic support shell is designed to be placed inside the
cover to provide additional support to the back.
932165 Rev. C
WARNING
3
1
Clamp Hardware
®
.
4
III. USE AND MAINTENANCE
2
Strap Attachment
Laundry Care Symbols
Machine wash in warm water
(50° C)
Only non-chlorine
bleach, when needed
Drip dry
Do not iron
Do not dry clean
3
Advertisement
