Package Check Upon Receipt; Packaging Disposal; Chap.4 - Installation; Setting Up Of The Machine - Univex UFP13-01 Operating And Maintenance Manual

Table of Contents

3.2 - PACKAGE CHECK UPON RECEIPT

Upon receipt of the package containing the Vegetable cutter, check accurately that the package has not been damaged

during transport.

If the package shows signs of damage caused during transport, the carrier must be informed immediately; moreover a

detailed report on the extent of the damage caused to the machine must be notified to the carrier within three days from

the delivery date on the shipping documents. DO NOT OVERTURN THE PACKAGE!! When the package is transported,

make sure the box is lifted by the 4 corners (parallel to the ground).

The components of the packaging (cardboard, pallet, plastic straps and polyurethane foam) are urban solid waste; there-

fore they can be easily disposed of.

If the machine has to be installed in countries where specific regulations are in force, packaging must be disposed of in

compliance with such regulations.

The vegetable cutter must be installed on a suitable and adequate size work table refer to Fig.n°12, (and therefore suffi-

ciently large); the machine must be solid, stable and fixed at a height of 80 cm from the ground. Moreover the machine

must be installed in a room with max. 75% non saline humidity at a temperature between +5°C e +35°C; in a location

and environment that does not provoke malfunctions or faults in the machine.

4.1.1 - COLLECTING BOWL

If the Vegetable cutter is provided with a collecting bowl, place it under the mouth of the machine, so as to cover the pro-

duct exit

(Fig. n°14).

Fig. n°14 - Collecting bowl

4.2.1 - VEGETABLE CUTTER T.M. (115 Volt, 60 Hz)

The Vegetable cutter is equipped with a power supply cable with a SJT 16 AWG mm

section; length 1,5 m and a NEMA

5 plug.

Connect the Vegetable cutter to 115 Volt 60 Hz, by interposing a differential thermomagnetic switch 10 A I = 0,03 A.

Check correct machine earthing.

Moreover check that the specifications on the rating plate-serial number

correspond to the specifications pro-

(Fig. n°15)

vided in the consignment and delivery note.

Fig. n°15 - Rating plate - serial number

Table of Contents