Table of Contents
Advertisement
CHAP.6 - MAINTENANCE AND ADVICE
6.1– FOREWORD
Before performing any maintenance operation, it is necessary to:
Disconnect the plug from the mains to isolate it from the mains power supply.
6.1.1 - BELT
The drive belt does not require adjustment. In general after 3-4 years, it must be replaced, in this case call the
"SERVICE CENTRE".
6.1.2 - FEET
Feet may deteriorate or lose elasticity, reducing machine stability. If support feet show signs of wear or damage, replace.
6.1.3 - POWER SUPPLY CABLE
Periodically check for wear in the power supply cable. If the power supply cable shows signs of wear or damage call the
"SERVICE CENTRE" for a replacement.
6.1.4 - DISCS
With time the blade could worn.
For DTV, DT 2, 3, 4, 7, 9 and PS 6, 8, 10, 20 discs; it is necessary to buy new discs.
For DF 1, 2, 3, 4, 5, 8, 10, 14 and DQ 4, 6, 8, 10 discs, it is possible to replace the blade.
In this case, call the "SERVICE CENTRE" indicating the name of the disc.
6.2 - WHAT TO DO IF...
6.2.1 - The fixing of the discs is faulty:
Check that the discs and the disc support pin are clean.
6.2.2 - The lid does not lock:
Check that the lid is installed correctly and that it is clean .
6.2.3 - The product is not cut correctly:
Check that the blade is not worn.
6.2.4 - The product does not go out correctly or is badly cut:
Check that the discharging spatula has not been assembled with the DT discs (the whole set); DF 1, 2, 3, 4; DQ 4; that
the bowl is not full and that the exit opening is not obstructed.
6.2.5 - The machine locks:
Check that the product is not frozen or too hard and that the power supply is the one indicated on the rating plate
.
15)
6.2.6 - The micro on the pusher handle and on the lid do not work:
Check that they are not dirty.
6.2.7 - The machine does not start:
Check that all the safety devices are correctly installed (See Chapter about safety devices 1.3); that the plug and the
switches are correctly connected.
CHAP.7 - CLEANING OF THE MACHINE
7.1 - FOREWORD
The machine must be cleaned at least once a day. If necessary clean when required during the day.
All the Vegetable cutter parts that come into contact directly or indirectly with the food product must be cleaned
thoroughly.
Before starting cleaning operations, it is necessary to:
disconnect the machine plug from the mains to isolate it from the mains power supply.
12
(Fig. n°
Advertisement
Table of Contents
