Table of Contents
Advertisement
Pay attention to hazards of injury caused by cutting and/or sharp machine components during cleaning o
handling of discs.
7.2 - CLEANING PRODUCTS
The machine must be cleaned with a normal detergent at ambient temperature, with a wet cloth.
It must never be cleaned with pressurised water, water jets, do not use brushes or other tools or anything that could
damage the machine.
N.B. DO NEVER WASH THE MACHINE PARTS IN THE DISHWASHER.
7.3 - PROCEDURE
Disconnect the machine from the power supply.
Remove the lid and the discs, the spatula, the pestle, the bowl and/or the chute
Clean accurately the inside of the mouth, the operating area and the disc support pin.
Moreover clean all the external surfaces and the pusher handle. Dry with a cloth and reassemble the machine.
PRODUCT INLET
CYLINDER
LID
SP DISC
JP
DISC
Fig. n°23 - View of the machine disassembled for cleaning.
CHAP.8 - SCRAPPING
8.1 - PUTTING THE MACHINE OUT OF SERVICE
If for some reason, you decide to put the machine out of service, make sure nobody can use it:
disconnect it from the mains and eliminate electrical connections.
8.2 - SCRAPPING
When the machine is out of service, it can be disposed of. To scrap the machine contact your local Specialised Waste
Treatment Centre, separate components (refer to chap.1 § 2.2).
PUSHER HANDLE
PIN
MOUTH
DISCHARGING SPATULA
OPERATING AREA
PESTLE
13
.
(Fig. n°23)
BOWL
Advertisement
Table of Contents
