Table of Contents
Advertisement
4.3 - WIRING DIAGRAMS OF THE VEGETABLE CUTTER
Fig. n°16 - Wiring diagram
4.4 - FUNCTIONAL CHECK
To check the correct machine operation, proceed as follows:
a) Turn ON pushbutton "I" and stop pushbutton "0" and check that the corresponding pilot lights turn on and off
17).
b) Check that the motor stops and then turns on when you lift or lower the pusher handle.
c) Check that the machine stops when your remove the lid and that it turns on by pressing pushbutton START "I" only if
the lid is correctly installed.
Fig. n°17 - Control panel.
CHAP.5 - USE OF THE MACHINE
5.1 - DISCS ASSEMBLY
A Choose one of the following discs DF 1-2-3-4-5-8-10-14, DTV, DT 2-3-4-7-9, or DQ 4-6-8-10; remove the steel or
aluminium lid, and place the disc on the shaft. Rotate the disc until it is fixed. Replace the stainless steel lid fastening
it with the specific hinges or the aluminium lid fastening it with the knob.
B (TO CUT CUBES)
Choose the couple of discs among PS8-DF8, PS10-DF10, PS20-DF14. Place the first disc PS. with the cavity turned
on the right side placing yourself in front of the machine. Then install the DF disc, proceeding as described in point
"A"
(see Fig. n°24).
NB: NEVER USE THE DISCHARGING SPATULA WITH COUPLED DISCS PS-DF.
C If the machine is supplied with a discharging spatula
DTV, DT 2-3-7-9, DQ4. The spatula must be assembled on the disc support pin before any other disc (
After having assembled the spatula, proceed as in point "A".
we advise to use it with the following discs DF 1-2-3-5,
(Fig. n°6),
10
(Fig. n°
CAUTION!
.
see Fig. n°18)
Advertisement
Table of Contents
