Kinetico Kube Manual page 9

9
Connect the Cartridges
Align the tabs on the cartridge body
with the tab holes on the face of the
Kube. Fully insert the cartridge and then
twist to lock into place.
a key fitting into a lock. Twist clockwise
to lock in place. The raised area on the
end of the cartridge cap should be lined
up with the lock icon
with the second cartridge.
11
Open Your Faucet
Turn on the cold
water at your faucet.
13
Flush Cold Water
Let water continue to run out of faucet for about five minutes to activate
your filter cartridges. While you wait, double check all connections again,
and make sure nothing is leaking. After five minutes turn off your faucet.
Wait 10 minutes and then turn the cold water back on for another 3
minutes. After 3 minutes turn off your faucet. You are now ready to enjoy
the benefits of your new Kube.
Note: If your tap/faucet has a filter screen at the end, please remove and clean
to ensure water flow is not obstructed. Remember to empty your drip tray.
Congratulations!
Your Kube is installed! Before you put this manual away, take a minute to register your
Kube to activate your warranty. With your mobile device, just scan this QR code or visit
www.kubewater.com/register.aspx to enjoy additional benefits of registration. don't forget
to check out the great discounts under our Filters for life program.
Installation Questions or Concerns, Call us first!
For help with assembly or product information, call our toll-free number:
1-800-544-4233. our staff is ready to take your call 7 days a week, 24 hours
a day. or email us: customerservice@kubewater.com during normal business hours.
please also check out our FaQ page and installation video at www.kubewater.com
TIP: It will be like
. Do the same
TIP: See Kube Life Guide.
10
Turn Water Back On
Turn the cold water on at the inlet. Do
this slowly and watch closely to ensure
there are no leaks, at the shut off valve
or at the back of the unit. If you see a
leak, turn it off again and double check
connections.
12
Put Your Kube to Work
Turn the blue by-pass knob until
the white indicator points to the
filtered water icon
knob will not turn unless both
cartridges are completely installed.
Water will not flow unless the by-
pass knob is turned. Note: Each time
the by-pass knob is used, the bottom
tray must be emptied.
TIP: The
7