Connecting Your Kube - Kinetico Kube Manual

Connecting Your Kube

1
Check Clearance
Clean out the area under your sink,
and ensure that there is enough
room for your Kube. Kube must
be installed in upright position on
a level surface. Make sure the back
of Kube isn't touching the back of
the cabinet; you'll need space for
the connections.
3
Disconnect Cold Water
Supply
Using a wrench, disconnect the cold
water supply line from the shutoff valve.
Do NOT disconnect the hot water!
Place a towel or paper towels under the
sink to collect any water that may run out
of the cold water line.
Hot
TIP:
Cold
2
Shut Off the Water
Turn off your cold water at the inlet. Turn
on your faucet to make sure that the water
is completely off.
is usually on the right side.
Hot
4
Connect the Adapters
Two adapters are provided in the Kube
Installation Kit. Thread the female adapter
onto the cold water shutoff valve, and
thread the male adapter onto the cold
water supply line, as shown. Hand-tighten
each adapter.
Cold
TIP: The cold water valve
Cold
5