Timeguard TRT035N Operating Instructions Manual page 10

• The daylight saving option (GMT=OFF/BST=ON) will flash, by default this
will be set to ON. Use the Up/Down arrow buttons to alter the setting
if required. Press the Select button once to confirm and return to re-enter
the date and time from the beginning, or press the Set button once
to confirm and exit.
Note:
• If no button is pressed, it will time out after 60 seconds and return
to the main screen showing day, time and output status.
• The display light will also time out after 15 seconds after the last button
9
is pressed.
• The Set button can be pressed to exit the date and time entry at any stage.
10. Programming Time/Temperature
Periods
Note:
• There are no OFF periods with this controller. As soon as a Start time begins,
heat will be demanded until the temperature reaches/falls to the selected
set point, then it will move on to the next Start time/temperature period,
and so on. The closest you can get to turning the TRT035N programmable
thermostat OFF, will be to set the selected period(s) to 10°C, this way
the heating will not turn ON unless the temperature drops below these
set points.
• If you do not want a higher temperature period in the middle off the day,
adjust the temperature for this period downward, to match those of the
proceeding and subsequent period temperatures.
Use Up/Down arrow buttons
The DLS will The DLS set to
flash, OFF for ON for BST
GMT by default
to alter if required
Use Set to confirm
and exit
Main screen showing day,
time and output status