Battery
Charging
6
EDA60K-0 uses 3.7V rechargeable lithium ion battery as its main
power supply. The battery capacity is 18.9 watt/hour. Battery life is
influenced by many factors, such as: screen brightness, the length of
time before the screen automatically go to sleep, input configurations,
extreme temperature and using behaviors, etc.
Honeywell suggests you to keep the battery charged to avoid data
loss. Change battery only after switching off the device as per normal.
Switch on the device after completing change of battery.
If you need to buy a replaceable battery, please contact regional
resellers.
Warning: Improper use of the battery of this device can cause a fire
or chemical burns. Please don't disassemble the battery or heat it
to 100 ° C (212 ° F) and above, or incinerate the battery. Make sure
waste batteries are properly disposed. Keep out of reach of the
children.
We would recommend using only Honeywell's lithium battery; any
damage caused by use of non-Honeywell battery is not covered by
warranty.
Before using EDA60K-0, you need to make sure the battery (model
number AB18) is fully charged. You can charge the battery before or
after installing it to EDA60K-0. It will take about 5 hours for the battery
to be fully charged using original quad charger (cradle charger or
otherwise).
We would recommend using Honeywell's original charger; any
damage caused by use of non-Honeywell charger is not covered by
warranty.
User Guide for ScanPal EDA60K-0 Handheld Computer