Page 1
UVLED 5mm – 192 UV LEDs UVLED1 1W – 48 UV LEDs LED STROBE 5mm – 192 White LEDs User’s instruction manual This manual contains important information about the safe installation and use of this product. Please read this instruction manual carefully before installing or operating Please keep these instructions in a safe place for future reference www.lightemotion.com.au...
CONTENTS SECTION Page INTRODUCTION, UNPACKING FEATURES, INSTALLATION MAINTENANCE & PERIODIC CHECKS CONNECTIONS AND CONTROLS POWER, FUSE DIP SWITCHES, STAND-ALONE MASTER/SLAVE MODE, DMX MODE DMX LEADS, DMX TERMINATORS DMX CHANNEL INFORMATION FAQ, SPECIFICATIONS Please note that as part of our ongoing commitment to continuous improvement and product development, the specifications in this manual are subject to change without notice.
FEATURES • Automatic mode • Strobing mode • Audio Activated with sensitivity control • Master/Slave linkable • DMX-512 controllable 3 channels INSTALLATION CAUTION: For safe mounting read the following instructions carefully: • Use suitable hook clamps* for hanging the lighting effect •...
5. DMX input socket 6. DMX output socket POWER CAUTION: This lighting effect is designed to operate at 240V. Power Consumption UVLED: 55W Power Consumption UVLED1: 12W Power Consumption LEDSTROBE: 12W FUSE CAUTION: Only use the correct fuse as specified on the rear panel of the lighting effect.
DIP SWITCHES The DIP switches allow the user to change the mode and operation of the lighting effect by setting the switches to different combinations. To determine the starting address for the each lighting effect you should refer to your DMX controller user manual. CALCULATING THE STARTING ADDRESS To calculate the starting address you add the value of all the switches which are ‘ON’...
MASTER/SLAVE MODE CONNECTIONS To connect multiple units in Master/Slave mode you need to connect a 3 pin DMX lead (Refer to Fig 7) from the DMX output socket of the master to the DMX input socket of the slave, then from the DMX output socket of the first slave to the DMX input socket of second slave and so on and so forth.
DMX LEAD The DMX lead is used to link up multiple units. For Wiring connections refer to fig 7. DMX OUT DMX IN DMX 512 FUNCTION DATA - DATA + DMX TERMINATOR A DMX terminator helps to reduce ‘noise’ on the DMX chain, and makes the light respond to control more accurately.