Configuring A Wlan Ap Acl; Copying An Acl - H3C WX5500H series User Configuration Manual

Step
Configure or edit a rule.
5.
(Optional.) Add or edit a rule
6.
comment.

Configuring a WLAN AP ACL

WLAN AP ACLs match packets from WLAN APs based on the MAC address or serial ID.
To configure a WLAN AP ACL:
Step
Enter system view.
1.
Create a WLAN AP ACL and
2.
enter its view.
(Optional.) Configure a
3.
description for the WLAN AP
ACL.
(Optional.) Set the rule
4.
numbering step.
Configure or edit a rule.
5.
(Optional.) Add or edit a rule
6.
comment.

Copying an ACL

You can create an ACL by copying an existing ACL (source ACL). The new ACL (destination ACL)
has the same properties and content as the source ACL, but uses a different number or name than
the source ACL.
To successfully copy an ACL, make sure:
• The destination ACL number is from the same type as the source ACL number.
• The source ACL already exists, but the destination ACL does not.
To copy an ACL:
Step
Enter system view.
1.
Command
rule [ rule-id ] { deny |
permit } [ ssid ssid-name ]
rule rule-id comment text
Command
system-view
acl wlan ap { acl-number | name
acl-name }
description text
step step-value
rule [ rule-id ] { deny | permit }
[ mac mac-address mac-mask ]
[ serial-id serial-id ]
rule rule-id comment text
Command
system-view
10
Remarks
,
By default a WLAN client ACL does not
contain any rules.
By default, no rule comment is
configured.
Remarks
N/A
By default, no ACL exists.
The value range for a numbered
WLAN AP ACL is 200 to 299.
Use the acl wlan ap acl-number
command to enter the view of a
numbered WLAN AP ACL.
Use the acl wlan ap name
acl-name command to enter the
view of a named WLAN AP ACL.
By default, a WLAN AP ACL does
not have a description.
By default, the rule numbering
step is 5 and the start rule ID is 0.
,
By default a WLAN AP ACL does
not contain any rules.
By default, no rule comment is
configured.