Panasonic MC-RS765W487 Operating Instructions Manual page 12

Robotic vacuum cleaner (domestic use)
Table of Contents

Advertisement

Charging
Charging
The battery is not fully charged at the time of purchase, so please be sure to
charge before use
(full charge takes about 2.5 to 5 hours)
To help make the battery last longer
To help make the battery last longer
If the unit is not used for one month or more, charge the unit fully, turn the main power switch off for
storage, then recharge the unit at least once half a year thereafter. (Storing the unit in an uncharged
state will adversely affect the performance and lifespan of the battery.)
Recharge in a room where the temperature is between 5 ℃ and 35 ℃ . The unit cannot charge
properly if the room is too cold or too hot (such as when the room receives direct sunlight). The
operating time will be shortened and recharging times will increase.
1
1
Turn on the main power switch.
Turn on the main power switch.
① Press
Request
2
2
Put the main unit in the charging base
Put the main unit in the charging base
(The status display lamp will gradually turn from dim to
bright, and then from bright to dim repeatedly)
 How to read the lamps
Charging
Charging complete
Request
• When the status display lamp on the main unit doesn ' t
light or goes out immediately, try putting the main unit in
the charging base again (If the main unit is correct placed,
the status display lamp will gradually turn from dim to
bright, and then turn from bright to dim repeatedly)
• When the unit is not to be used for 6 months or more, the
battery may over-discharge and operating time may be
reduced, so make sure you recharge it before using it again
• In order to avoid interference with TV sets, telephones,
etc. (such as noise), please charge more than 1 m away
from these appliances.
12
② Open
• Under normal circumstances, leave the main power switch on
(The unit cannot charge if the main power is switched off.)
Gradually from dim to bright,
and then from bright to dim repeatedly
ON
OFF
Status display lamp
Always on
blue
(
)
Note
• The temperature of the battery can change depending on
the ambient temperature, usage time, and other usage
conditions. When the temperature of the battery is too high
or too low, the unit waits until the battery reaches a level
suitable for charging, so charging times may increase.
• The main unit and charging base may become warm while
charging, but this is normal.
• The length of time the unit can run varies depending on the
temperature of the battery and other usage conditions.
• When AC adapter or charging base is inserted into a power
socket, there will be about 1 W of power consumption even
if they do not charge.
Click
Click
Status display lamp
When charging is abnormal,
refer to " Troubleshooting "
(P. EN23)

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents