Insert/Remove An Sd Memory Card - Panasonic WV-X8570N Important Information Manual

Insert / remove an SD memory card
Note:
⿟ Refer to the Operating Instructions on the Panasonic support web site for further information
about the SD memory card settings.
■ Insert an SD memory card
【１】
Remove the dome cover from the camera, insert an SD memory card fully into the SD slot
until a click is heard.
IMPORTANT:
⿟ Dome cover is fixed to the camera body by the installed auxiliary wire, so please do not
remove it.
⿟ The dome cover is not fixed temporarily. Take care not to hit the dome cover against
periphery.
⿟Insert the SD memory card with its label facing outside.
⿟ Insert the SD memory card with its back end at the same height as the lower part of the
center SD slot until it makes a clicking sound.
⿟ Take your fingers off the SD memory card and check that its back end does not protrude
over the upper part of the SD slot.
⿟ After the SD memory card has been inserted, press the SD ON/OFF button, and make sure
the SD MOUNT indicator is continually lit.
⿟ If you do not press the SD ON/OFF button after inserting the SD memory card, the SD
MOUNT indicator is automatically lit approximately 5 minutes later.
Rear end of SD
memory card
【2】
Attach the dome cover to the camera.
IMPORTANT:
⿟ Fasten the dome cover fixing screws along the diagonal direction.
(Recommended tightening torque: 1.37 N·m {1.01 lbf·ft})
22
SD ON/OFF button
SD slot
SD MOUNT indicator
SD memory card
(with label facing outside)