Panasonic WV-X8570N Important Information Manual page 20

■ Indicators and buttons
* Image of camera 1 is omitted for simple explanation.
B SD ON/OFF button
C LINK indicator
A
INITIAL SET button
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera. Disconnect the Ethernet cable from the camera.
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds. In about 2 minutes later, the camera will
start up and the settings including the network settings will be initialized. Retry if the camera
does not start up normally.
IMPORTANT:
⿟ When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
⿟ Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
B
SD ON/OFF button
⑴ When the SD ON/OFF button is pressed (less than 1 second), the SD MOUNT indicator lights
up in green and data can be saved to the SD memory card.
⑵ When the SD ON/OFF button is held down (about 2 seconds), the SD MOUNT indicator lights
off and the SD memory card can be removed.
C LINK indicator
⿟ When the camera is able to communicate with
the connected device
D
ACT indicator
⿟ When data is being sent via the network camera
SD slot
D ACT indicator
20
INITIAL SET button
A
F SD MOUNT indicator
ESD ERROR indicator
Lights orange
Blinks green (accessing)