Advertisement
To install the lower panel and front cover:
1.
Position the cover plate (packaged with hardware kit) into the center opening
of the lower panel.
2.
For touchscreen consoles: Install the coax coupler, star washer, and nut into
the jack plate on the lower panel and tighten (Figure 9).
3.
Connect the coax cable to the inside end of the coax coupler
connector using a 7/16-inch open-end wrench.
NOTE
Check the bend radius (about 6 inches, 15.24 cm) on the coax cable so
that it is at a natural angle.
4.
Attach the Ethernet coupler
9) and plug the Ethernet cable into the coupler.
Figure 9
. Tighten the
into the jack plate on the lower panel (Figure
5.
For all consoles: Attach the lower panel using two screws
power cable through the slot. Fully tighten fasteners on the panel (see arrow
in Figure 11).
Figure 10
, and route the
Figure 11
10
Advertisement
