Advertisement
Route the power supply internally
Depending on the site location and distance from an outlet, you might need to
route the power supply either internally or externally.
WARNING
DO NOT allow cables to touch any moving parts around the lift motor
body—lift screw, yoke, or ramp. Run the ramp through its movement
path a few times and have someone else watch to make sure no cables
are caught up or hanging loosely.
For non-touchscreen consoles:
Make sure the cables are secured in the cable clips
For touchscreen consoles:
1.
Hook the Power Supply Bracket (included in console box) onto the right
upright support (Figure 3).
2.
Coil up all cables—coax, power and Ethernet—and hold the power supply
on the holder with one hand, and with the other hand, thread a large zip tie
B
around the upright support
NOTE
Make sure you thread the zip tie through the designated slots in the
power supply bracket.
3.
Pull the zip tie tight only after you have reduced any slack by pulling the cables
tighter from the top.
4.
Insert the ground connector, and then secure the cables inside each of the
C
three cable clips
attached to the right upright support. Leave cable
connectors loose until after the lower panel is installed (see Install lower panel
and front cover).
To complete the console installation, refer to the installation guide shipped
with your console.
C
(Figure 2).
(Figure 3).
A
Figure 2
Figure 3
7
Advertisement
