Advertisement
Install EFX arms
To install moving arms:
1.
Insert the shaft of the moving arm to the center mount (Figure 15) and
align pre-installed set screws to the shaft (Figure 16).
Figure 15
2.
Insert one screw
next to it and fully tighten all screws, including pre-
installed ones to 100 in-lb (11.29 N-m) of torque.
Figure 16
3.
Cut the zip ties holding the link arms together.
4.
Place the inner cover between the link pairs and attach the link to the moving
arm using a 9/16-inch socket wrench on the pre-installed bolts and tighten to
300 in-lb (33.90 N-m) of torque.
Figure 17
5.
Attach the outer link covers (shipped in hardware kit) using two Plastite®
screws
and tighten them to 20 in-lb (2.25 N-m) of torque.
12
Advertisement
