To install the yoke cover and shelf:
1.
Attach the yoke cover to the back of the base mount using two screws
(Figure 12).
NOTE
Make sure the small latches engage with the side covers.
2.
Fully tighten the fasteners
3.
Position the shelf into the tabs near the top of the yoke cover, then secure it
using two screws
(Figure 13).
4.
Push in the edge of the shelf and squeeze the two hooks and latches until they
engage or snap into place.
Figure 12
5.
Attach the shelf at the top using two screws
lb (3.95 N-m) of torque.
to 35 in-lb (3.95 N-m) of torque.
Figure 13
. Tighten the fasteners to 35 in-
To attach the anchors:
1.
Place an anchor on top of an arm frame and secure it using two screws
Figure 14
2.
Attach the second anchor to the other arm.
.
11