Advertisement
Route the power supply externally
WARNING
DO NOT allow cables to touch any moving parts around the lift motor
body—lift screw, yoke, or ramp. Run the ramp through its movement
path a few times and have someone else watch to make sure no cables
are caught up or hanging loosely.
For touchscreen consoles:
1.
Coil up all cables—coax, power extension
place with one hand, and with the other hand, thread a large zip tie around
the upright support (Figure 4).
NOTE
Make sure you thread the zip tie through the designated slots in the
B
power supply bracket
2.
Pull the zip tie tight, making sure you have enough slack in the power and
extension cables.
3.
Insert the grounding jumper into the ground connector, and then secure the
cables inside each of the three cable clips
support. Leave cable connectors loose until after the lower panel is installed
(see Install lower panel and front cover ).
To complete the console installation, refer to the installation guide shipped
with your console.
A
, and Ethernet—and hold them in
.
C
attached to the right upright
Figure 4
8
Advertisement
