Advertisement
800/600 Line EFX® Assembly Guide
Follow the steps in the order listed in this assembly guide. For more product
information, visit us at www.precor.com.
WARNING
At least two people are required to assemble the equipment. DO NOT
attempt assembly by yourself.
Assembly requirements
IMPORTANT
Before you fully tighten a fastener, check that its head is flush with the surface of
the equipment. If not, cross-threading may have occurred. DO NOT attempt to
rework the assembly as more damage to the equipment will occur. Instead,
contact Customer Service at www.precor.com.
We recommend you:
• Assemble the equipment close to where you plan to use it.
• Assemble the equipment on a solid, flat surface, so that it remains level and
stable.
• Locate the equipment at least 19.7 inches (0.5 meter) away from walls or
furniture on either side of the equipment, and 19.7 inches (0.5 meter) away from
objects behind or in front of the equipment.
• DO NOT move the equipment without assistance.
Torque measurements
Use the following torque measurements to tighten the fasteners. If a torque is not
provided, then fully tighten the fastener with the appropriate tool.
• Self-tapping screws 35 in-lb (3.95 N-m)
• Flathead screws 100 in-lb (11.29 N-m)
• Set screws 100 in-lb (11.29 N-m)
• Plastite® screws 20 in-lb (2.25 N-m)
Display mount
Badge plate and
rubber gasket
Front cover
Lower panel
Console
Moving arms
Shelf
Yoke cover
Pedals
Link
4
Advertisement
