Download Print this page

Elaflex ZVA Slimline 2 Assembling Manual

Hide thumbs Also See for ZVA Slimline 2:

Download this manual

DISASSEMBLING

These parts can by disassembled at room temperature, by hand. Using a vise ( smooth jaws, to protect the

plastic guard ) facilitates the procedure.

Scuffguard

EK 044

Product Sleeve

EK 043

1) With a turning movement, pull off Product

Sleeve EK 043 ( or Splashguard EK 652 )

towards the spout tip.

Do not use tools ( e.g. screwdriver ) to

pull off the Scuffguard.

Tools might overscretch and permanently

deform the Scuffguard. In this case, the

Scuffguard does no longer fit onto the nozzle

body so that the Product Sleeve cannot be

assembled correctly.

August 2015

ZVA Slimline 2 – Disassembling and

Assembling Scuffguard / Product Sleeve

2) Put fingers below the Scuffguard EK 044 and

pull it towards the spout tip to remove.

To remove hardened scuffguards please use

our Safety-Cut-Off Tool EW-CUT.

For further information about the EW-CUT

please read at our manual 'Safety-Cut-Off

Tool'.

EW-CUT

Need help?

Do you have a question about the ZVA Slimline 2 and is the answer not in the manual?

Page 1 ZVA Slimline 2 – Disassembling and Assembling Scuffguard / Product Sleeve DISASSEMBLING These parts can by disassembled at room temperature, by hand. Using a vise ( smooth jaws, to protect the plastic guard ) facilitates the procedure. Scuffguard EK 044...
Page 2 ASSEMBLING The scuffguard can be mounted by hand, at room temperature. To facilitate assembling for large quantities or at low ambient tempertures, it is admissable to warm up scuffguards, e. g. with warm air or water ( 45° C up to max.