Battery And Battery Level Indications; Power Supply - Gemini 810 User Manual

CONTROLS, OPERATION & USE

14 - BATTERY and BATTERY LEVEL INDICATIONS

The Gemini 810 + 980 diode laser is equipped with a powerful nano-core lithium polymer battery
capable of delivering a full day of laser usage and lasting several days in Standby mode. Simply
connect the provided power supply to the rear of the unit and charging will start immediately.
It is recommended to fully charge the laser unit prior to initial use after unpacking.
The battery level indicator is located at the upper right corner of the display and shows battery
percentage remaining.
100%
75%
50%
25%
"Please connect power supply" reminder.
0%
- Standby time refers to when the unit is off and not being used.
- Usage time refers to constant use without interruption

15 - POWER SUPPLY

Use only the provided 13V, 4A AC/DC power supply for charging the system battery and as an
alternate laser power source. During initial setup, use the AC/DC power supply for one full hour
to fully charge the battery.
Plug the power supply into an AC outlet and connect to the corresponding connector on the
rear of the laser unit. Only use the power supply provided with the system.
WARNING: To avoid the risk of electric shock, this equipment must only be connected to a
supply main with a protective earthing conductor.
7 Days
Standby Time:
5 Days
Standby Time:
3 Days
Standby Time:
1 Day
Standby Time:
Minimum of 60 minutes of charging is required before first use
1.5Hours
Usage Time:
1.0Hours
Usage Time:
30 min
Usage Time:
15 min
Usage Time:
25