Gemini 810 User Manual page 21

CONTROLS, OPERATION & USE
08 - CUSTOMIZING PRESET PROCEDURE SETTINGS
The Gemini laser's preset procedure settings can be customized. To save your own procedure setting,
press PROCEDURES once to bring up preset procedures on the display and navigate to the procedure
you would like to customize.
When a particular procedure
is highlighted, press and hold
PROCEDURES for 3 seconds.
You will hear two audible
beeps and the
Indicator and Power Dial will
start flashing on the display.
Use UP/DOWN or LEFT/RIGHT
to adjust the new average
power to the desired setting.
To save the setting, press and
hold the PROCEDURES key
for 3 seconds. You will hear
two audible beeps when the
setting has been saved.
To reset all preset procedure
settings to the factory default,
press PROCEDURES once to
bring up preset procedures
on the display, then press
and hold the PROCEDURES
key for 10 seconds. You will
hear three audible beeps
when the settings are reset.
Hold 3 seconds = Customize / Save
Hold 10 seconds = Factory Reset
Power Indicator and Power
Power
Dial will start flashing on
the display.
21