Advertisement
Capacity Per Hour
Tank Capacity
Motor Size
Electric Usage
(Electric booster must have 16
gallon holding tank)
Steam Consumption
at 20 psi
Final Rinse Peak Flow
at 20 psi min.
Final Rinse Consumption
at 20 psi min.
Exhaust Requirements
Peak Rate Drain Flow
Shipping Weight
Current Draw Amps
208/3/60
230/1/60
240/3/60
480/3/60
380/3/50
Note: Due to product improvement we reserve the right to change information and specifications without notice.
CA-3 & DA-3 Technical Manual 2018
6245 State Road • Philadelphia, PA 19135 • PH: 800-344-4802 • FX: 215-624-6966 • www.insingermachine.com
®
50 racks/276 sheet pans
62 gallons
(2) 5 hp
5 kW wash tank
(2) 9 kW booster 40º rise
(2) 24 kW booster 70º rise
40º rise
20 lbs./hr. tank
50 lbs./hr. booster average
476 lbs./hr. booster peak
70º rise
20 lbs./hr. tank
88 lbs./hr. booster average
834 lbs./hr. booster peak
22.4 gallons/minute
5.6 gallons/cycle
140 gallons/hour
600 CFM
16 gallons/minute
1500 lbs.
Steam
Electric w/o booster
34.1
48.0
N/A
N/A
31.1
43.1
15.5
21.5
18.8
26.4
PART 1 TECHNICAL INFORMATION
SPECIFICATIONS
CONSTRUCTION-
Hood and tank constructed of 14 gauge 18-8
type 304 S/S. Hood unit of all welded seamless construction. S/S
frame, legs and feet. All internal castings are non-corrosive lead
free nickel alloy or bronze.
DOORS-
A front inspection/clean-out door and two
simultaneously opening operating doors. Operating doors
balanced by externally mounted springs. Extra large die formed
18-8 type 304 S/S doors ride in all S/S channels. A triple ply
leading edge on the door channels made of S/S.
PUMP-
Centrifugal type "packless" pump with a brass petcock
drain. Construction includes ceramic seal and a balanced cast
impeller on a precision ground stainless steel shaft, extension or
sleeve. All working parts mounted as an assembly and removable
as a unit without disturbing pump housing. Two 5 hp motors,
standard horizontal C-face frame, drip proof, internally cooled
with ball-bearing construction.
CONTROLS-
Side-mounted control cabinet, NEMA 12 rated,
housing motor controls and overload protection, transformer,
contactors and all dishwasher integral controls. All controls safe
low voltage 24 VAC.
SPRAY SYSTEM-
Wash and rinse spray systems made of 18-8
type 304 S/S pipe threaded into cast hub assemblies. Upper and
lower spray assemblies are interchangeable and are removable
without the use of tools.
WASH-
4 power spinning wash arms above and 4 power spinning
wash arms below, each designed with 8 high pressure action
cleansing holes.
FINAL RINSE-
4 power spinning wash arms above and 4 power
spinning rinse arms below, each designed with 3 nozzles.
DRAIN-
Drain valve externally controlled. Overflow assembly with
skimmer cap is removable with the use of simple tools for drain
line inspection. Heater is protected by low water level control.
*Note: Exhaust requirements are for duct connections only.
www.insingermachine.com
4
DA-3
Pot and Pan Washer
800-344-4802
3_2012
Advertisement
