Touch Panel Calibration - Fujitsu TeamPad500 System User Manual

2.2 Touch Panel Calibration

2.2 2.2 2.2
The following calibration screen will appear. Follow the instructions on the screen. Tap the target
(+) with a stylus as it moves from the center to the four corners of the screen.
If the system detects the touch too far from the target, the calibration must be done again from the
beginning. When all the positions have been successfully tapped, the target ceases to be displayed
and the following message appears: "Press the ENT key to accept the new setting". Press the ENT
key to register the calibration data and terminate the function.
Settings".
Do not use an item with a sharp edge, such as a pencil or ballpoint pen, for tapping the screen, as
this may damage or break the screen. Do not place the palm of your hand on the screen when
tapping it.
Copyright 2001 by Fujitsu-ICL Systems Inc.
9 of 47
Tap the center of the target with the
stylus. Repeat as the target moves
around the screen.
Press the SFT+BKS key to cancel.
TeamPad 500 User's Guide
Proceed to "Date and Time