Touch Panel Calibration - Fujitsu TeamPad500 System User Manual

4.4 Touch Panel Calibration

After a period of time, you may experience that the Touch Panel seems too be "drifting", ie the
touch does not register correctly. If this is the case it will be necessary to re-calibrate the tapping
position.
While holding the SFT key down, press the ENT/SYS key. The following Volume and Battery
panel will be displayed.
Press "2" for the "Touch Screen Calibration" process to start. The following calibration screen will
open. Follow the instructions on the screen. Tap the target (+) with a stylus as it moves from the
center to the four corners of the screen.
If the system detects the touch too far from the target, the calibration must be re-done from the
beginning. When all the positions have been tapped, the target ceases to be displayed and the
following message appears: "Press the ENT key to accept the new setting". Press the ENT key to
register the calibration data and return to the Battery Status Window.
Copyright 2001 by Fujitsu-ICL Systems Inc.
40 of 47
Tap the center of the target with the
stylus. Repeat as the target moves
around the screen.
Press the SFT+BKS key to cancel.
TeamPad 500 User's Guide