4IPNET, INC. You may not alter or remove any copyright or other notice from copies of the content. All other brand and product names are claimed or registered marks of their respective companies or organizations.
Page 4
This declaration is only valid for configurations (combinations of software, firmware, and hardware) provided and supported by 4ipnet Inc. The use of software or firmware not provided and supported by 4ipnet Inc. may result in the equipment no longer being compliant with the regulatory requirements.
EAP330 Enterprise Access Point ENGLISH Preface Package Contents 4ipnet EAP330 is a high-end, dual radio 802.11 1. 4ipnet EAP330 x 1 b/g/n + ac MIMO Access Point (AP) with the best 2. Handbook x 1 performance for business and industrial applications 3.
Page 7
WES Buttons For IT administrators to easily setup WDS links with RF Card (B). Console Port To access EAP330 via the console interface. LED Indicator An LED indicator is available to show the power status. Use Kensington lock for anti-theft purpose.
2. Connect the EAP330 to your network device. Connect one end of the Ethernet cable to the Uplink port of EAP330 and the other end of the cable to a switch, a router, or a hub. EAP330 is then connected to your existing wired LAN network.
1. To access the Web Management Interface, connect the administrator PC to the Uplink port of EAP330 via an Ethernet cable. Then, set a static IP address on the same subnet mask as EAP330 in TCP/IP of your PC, such as the following example: IP Address: 192.168.1.100...
Page 10
EAP330 Enterprise Access Point ENGLISH Administrator Login Page 4. After a successful login to EAP330, a System Overview page of the Web Management Interface will appear, as depicted below. The Web Management Interface - System Overview Page 5. To logout, simply click on the Logout button at the upper right hand corner of the interface to return to the Administrator Login Page.
Page 13
ENGLISH Admin should be aware of Dynamic Frequency Selection (DFS) mandated on some channels of the 5GHz band. When an EAP330 detects interference, this mechanism will limit the ability to broadcast the SSID on one of the channels listed below: ...
Page 14
Step 3. Configure VAP (Virtual Access Point) Profile Settings VAP Configuration Page (VAP-1 shown) EAP330 supports up to 16 virtual APs (VAPs) per RF Card. Configure VAP profile settings: (a) Select the VAP Config tab to configure the settings of the desired VAP.
Page 16
Step 4. Configure WDS (Wireless Distribution System) Settings (Optional) To extend the wireless coverage, EAP330 supports up to 8 WDS links per RF card for connecting wirelessly to other WDS-capable APs, or peer APs. By default, all WDS profiles are disabled.
Page 17
Congratulations! Now, 4ipnet EAP330 is installed and configured successfully. After EAP330's network configuration is completed, please remember to change the IP Address of your PC Connection Properties back to its original settings in order to ensure that your PC functions properly in its real network environments.